REACT Parasol Zenith

The face plate of REACT Parasol Zenith is always flush, i.e. always in line with the suspended ceiling, which gives a stylish and discreet installation. The double outlets means that there is no need to lower the face plate for high air flow rates, maximum capacity (induction) is still achieved.

The casing is manufactured in galvanized sheet steel (zinc plated) The face plate is in prepainted sheet steel and aluminium RAL 9003, Coil in copper and aluminium.

Standard colour:

• RAL 9003 White (Signal white), gloss ratio 30 ± 6%

Alternative standard colours:

• RAL 7037 Grey (Dusty gray), gloss ratio 30-40%)
• RAL 9010 White (Pure white), gloss ratio 30-40%)
• RAL 9005 Black (Jet black), gloss ratio 30-40%)
• RAL 9006 White (White aluminium), gloss ratio 70-80%)
• RAL 9007 Grey (Grey aluminium), gloss ratio 70-80%)
• Other colours available on request

Suspension REACT Parasol Zenith has four mounting brackets for suspension and is installed using one threaded rod in each mounting bracket (Figure 21). A double threaded rod with a thread lock should be used if there is substantial distance between the overhead slab and the unit. A 200 mm threaded drop rod is used for surface mounting. Threaded drop rods and assembly fitting SYST MS M8 (Figure 20) are ordered separately. For installation in an existing T-bar system, the product is stabilised by the T-bar system and in this case it is sufficient to suspend the product from two brackets (diagonal).

Quick bracket For an even more efficient and time-saving installation, we have developed a kit for easier installation. PARASOL Z QUICK SUSPENSION KIT, consisting of 2 fixed brackets. The fixed brackets are fastened to the ceiling. The product can then be pushed into place without the use of tools. The brackets also feature an integrated fine adjustment of approx. 50 mm in height. (Figure 22).

Centring kit The centring kit can ideally be used on the ceiling system such as FOCUS E, FOCUS D and similar ceilings with concealed T-bar system or shadow line. The kit consists of 6 centring rails that are used to centre the product in specific suspended ceiling systems. (Figure 23)